AQUACUBE RV
QUICK START GUIDE
Step 1. Attach the 1 x gas and 2 x water adaptors to the inlet connections on the base of the shower, ensuring
that each adaptor is fitted with the black rubber “O” rings and tighten with a spanner.
– DO NOT FINGER TIGHTEN.
(IMPORTANT – Failure to include the “O” rings or tightening with a spanner will result in LP Gas &
water leaks causing failure in operation).
Step 2. Insert 2 x D batteries into battery compartment.
Step 3. Connect shower hose to water outlet.
Step 4. Connect pump hose to water inlet and pump power lead to pump socket.
Step 5. Connect 12V DC power lead (RED) into power socket and connect 12V cigarette plug into 12V
power source.
Step 6. Connect quick gas hose to gas inlet.
Step 7. Connect gas regulator to gas cylinder – tighten all gas connections and check for leaks using.
Companion Gas Leak Detector Spray or soapy water or gas leak detection spray – Turn gas cylinder ON.
Step 8. Submerge pump assembly into a large container of clean water. Ensure water level remains above the
pump assembly.
IMPORTANT! INITIAL SET UP INSTRUCTIONS
Please read carefully.
1 2 3 4
5 6 7 8
THIS APPLIANCE IS DESIGNED AND APPROVED FOR OUTDOOR USE ONLY
- NOT INTERNAL INSTALLATIONS
THIS APPLIANCE IS TO BE USED IN AN ABOVE GROUND OPEN AIR LOCATION
USE ONLY IN WELL VENTILATED AREAS
This appliance is not intended for the supply of drinking water
To Next Page
Need help?
General
