6-36 Upgrading the Desktop Computer
Writer: Debbie Thomson Saved by: Alyce Klingler-Castle Saved date: 06/13/97 5:32 PM
Pages: 37 Words: 5251 Template: c:\msoffice\templates\comm.dot
File Name Ch6.doc Part Number 270844-002
3. Remove the screws securing the drive cage and slide out
the drive cage 1.
4. Remove the three screws securing the power supply to the
back of the computer chassis.
5. Disconnect the power connector from the system board and
from any drives or other peripherals.
✎
Label each power connector, before disconnection, with
the connection location. After doing this, you can easily
reconnect power to the correct devices.
6. Slide the power supply toward the front of the computer
chassis, and lift up to remove 2.
Removing the Power Supply
Installing the Power
Supply
To install the power supply, complete the following steps:
!
WARNING:
This procedure should be performed only by qualified
personnel. Do not reconnect power to the computer until the
computer cover is replaced. Connecting the power before replacing
the computer cover can result in personal injury or equipment
damage.
1. Place the power supply in the computer chassis and slide
the power supply to the rear of the chassis.
2. Secure the power supply to the chassis with the three
screws.
To Next Page
Loading...
