. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Removal and Replacement Procedures 5-27
5.5.1 Memory Cover
The memory cover must be removed before either the memory boards or the Lithium
clock battery can be removed. To remove the memory cover, complete the following
steps:
1. Disconnect the AC power and any external devices (Section 5.3.1).
2. Undock the computer from the auxiliary base, if necessary (Section 5.3.2).
3. Remove all battery packs (Section 5.3.3).
4. Unsnap the door by pulling up on the wide end of the door. The case utility tool may
be used if needed.
Figure 5-24.
Removing the Memory Cover
Reverse the procedure to install the memory cover.
To Next Page
Loading...
