. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-38 Removal and Replacement Procedures
To install the CPU cover, reverse the procedure above and use the following steps to
ensure proper keyboard alignment.
1. It is critical for purposes of keyboard alignment that the screw identified below as
1 be installed first whenever a CPU bottom is reattached. Failure to follow this
directive will result in sporadic keyboard performance.
2. Screw 2 must be tightened next to firm up the keyboard location.
3. Screws 3 and 4 should follow next. All screws should be snug.
Figure 5-35.
Reinstalling Screws to the Bottom of the CPU
To Next Page
Loading...
