NOTE: If installing a new system board, ensure that the insulator is
installed between the system board and diskette drive. The gasket
over the keyboard connector must be tucked under the Chassis.
Chapter 3.16 PC Card (PCMCIA) Assembly
The PC Card assembly consists of the PC Card clip and PC Card rails. To
remove the PC Card assembly or to remove part of the assembly, follow
these steps:
Removing the PC Card Clip
To remove the PC Card clip, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The computer becomes top heavy when the keyboard assembly is removed and
the display is opened. To prevent damage to the display and the computer,
ensure that the display assembly is opened at a 90-degree angle.
To Next Page
Loading...
