2–36 www.hp.com Troubleshooting Guide
Troubleshooting Without Diagnostics
New network card will
not boot.
New network card may be
defective or may not meet
industry-standard
specifications.
Install a working, industry-standard
NIC, or change the boot sequence
to boot from another source.
Cannot connect to
network server when
attempting Remote
System Installation.
The network controller is
not configured properly.
Verify Network Connectivity, that a
DHCP Server is present, and that
the Remote System Installation
Server contains the NIC drivers for
your NIC.
System setup utility
reports unprogrammed
EEPROM.
Unprogrammed EEPROM. Contact an authorized service
provider.
Solving Network Problems (Continued)
Problem Cause Solution
To Next Page
Loading...
