7-46 Chapter 7, Removal and Replacement Procedures
Addendum 108431-001 (11-88) to
Manual No. 108033-003
2. Insert the prongs of the coprocessor removal
tool under one side of the coprocessor.
CAUTION
Do not press down on the handle of the co-
processor removal tool.
3. Using an upward motion, lift the side of the
coprocessor slightly (Figure 7-47).
4. Reposition the coprocessor removal tool on
the opposite side of the coprocessor, and lift
this side slightly. Continue repositioning the
coprocessor removal tool and lifting the
sides of the coprocessor until it is released.
Figure 7-47. Removing the 387 Coprocessor.
To Next Page
Loading...
