B-4
System Board Jumpers and Switches
Writer: Lydia Sanchez Saved by: Lydia Sanchez Saved date: 12/14/98 1:47 PM
Pages: 4 Words: 798 Template: d:\95office\templates\commapp.dot
File Name e_Appb.doc Part Number 166811-002
3. Remove the computer access panel. Refer to the
“Removing the Computer Access Panel” section in
Chapter 2.
4. Locate the jumper labeled E50.
Location of the E50 Jumper and Pins 1-3 on the System Board
5. Remove the jumper from pins 1 and 2, place it on pins 2
and 3 for approximately 30 seconds, then return it to pins 1
and 2.
6. Replace the computer access panel.
7. Reconnect the external equipment.
8. Plug in the computer and turn on power.
✎
When the CMOS jumper is removed, your passwords will become
invalid because the passwords are stored in the configuration
memory. You will need to reset your passwords and any special
system setups. Refer to the
Software Reference Guide
.
To Next Page
Loading...
