Drives
Hardware Guide 4–9
1. If the drive has a media tray, remove the media, then close
the tray.
2. Stop the drive as instructed in the preceding caution.
3. Slide and hold the MultiBay release latch
1
toward the
front of the notebook as you pull the drive or drive assembly
(a hard drive inserted into a MultiBay hard drive adapter) out
of the MultiBay
2
.
When a drive or drive assembly is correctly removed from the
MultiBay, the notebook beeps 3 times.
Ä
CAUTION: To prevent damage to the MultiBay when no device is in
the MultiBay, insert the weight saver to protect the bay opening.
The weight saver can be inserted or removed while the notebook is
on, off, in Standby, or in Hibernation.
Removing a drive from the MultiBay
265656-001.book!!Page!9!!Monday,!June!17,!2002!!10:00!AM
To Next Page
Loading...
