Initiating or restoring from hibernation
Hibernation cannot be initiated unless it is enabled. Hibernation is enabled at the factory.
To verify that hibernation remains enabled, Select Start > Control Panel > Performance and
Maintenance > Power Options > Hibernate tab. If hibernation is enabled, the Enable hibernation
check box is selected.
Task Procedure Result
Initiate hibernation.
●
Press the power button.
– or –
●
Select Start > Turn Off Computer.* Then,
hold down the shift key as you select
Hibernate.
In Windows XP Professional, if hibernate is
not displayed:
a. Click the down arrow.
b. Select Hibernate from the list.
c. Click OK.
●
The power lights are turned off.
●
The screen clears.
Allow the system to initiate
hibernation (with hibernation
enabled).
No action required. If the computer is running on
battery power, the system initiates hibernation
●
After 30 minutes of computer inactivity.
(factory setting)
●
When the battery reaches a critical low-
battery condition.
NOTE Power settings and timeouts
can be changed using Power Options in
Windows Control Panel.
●
The power lights are turned off.
●
The screen clears.
Restore from user-initiated
or system-initiated
hibernation.
Press the power button.†
●
The power lights are turned on.
●
Your work returns to the screen.
*If you have been registered to a network domain, the button you click will be called Shut Down instead of Turn Off
Computer.
†If the system initiated hibernation because of a critical low-battery condition, connect external power or insert a charged
battery before you press the power button. (The system may not respond if the discharged battery is the only power source.)
12 Chapter 4 Factory power settings ENWW
To Next Page
Loading...
