Adding or replacing memory modules
Memory Modules 1–11
12. To insert a memory module:
a. Align the notched edge 1 of the memory module with
the tab in the memory module slot.
Ä
To prevent damage to the memory module, hold the
memory module by the edges only. Do not touch the
components on the memory module.
b. With the memory module at a 45-degree angle from the
surface of the memory module compartment, press the
module 2 into the memory slot until it is seated.
c. Press the memory module 3 down, applying pressure to
both the left and right edges of the memory module, until
the retention clips snap into place.
To Next Page
Loading...
