Compaq Presario 5000 Series - Page 135

United States
STORE | PRODUCTS | SERVICES | SUPPORT | CONTACT US | SEARCH
Compaq Presario Internet PC 5000 Series Computers
Removal and Replacement Procedures
PRODUCT DESCRIPTION TROUBLESHOOTING ILLUSTRATED PARTS CATALOG
REMOVAL AND REPLACEMENT
PROCEDURES
JUMPER AND SWITCH
INFORMATION
SPECIFICATIONS
Electrostatic
Discharge
Service
Considerations
Preparation for
Disassembly
Serial Number
Side Access Panel
Graphics Card
Expansion Card
(Modem or Network
Card)
1394 Card
Memory Module
Hard Drive
Disk Drive
Removing the Top
Door
Removing the CD
Storage Door
(Lower Front Panel -
Open the CD Storage
Door)
Optical and Mass
Removing the 1394 Card, Continued
Removal
Remove the screw securing
the 1394 card
.
4.
Pull the 1394 card using
a gentle side-to-side rocking
motion from the connector
on the system board.
5.
Replacement
Important: The 1394 card rear
connector must be properly
inserted into the rear chassis slot
to ensure the card is properly
seated into the connector on the
system board.
Align the card with connector
on the system board and
rear connector slots on the
chassis.
1.
Reconnect the data cable and
the power cable.
2.
Replace the screw to secure
the 1394 card to the chassis.
3.