6. Separate the display bezel top edge (3) from the display assembly to access the camera module.
7. Remove the two Philllips PM2.0×3.0 screws (1) that secure the camera module to the display
enclosure.
8. Release the camera module (2) as far from the display enclosure as the camera module cable allows.
9. Disconnect the camera module cable (3) from the camera module.
10.
Remove the camera module and bracket.
Reverse this procedure to install the camera module.
36 Chapter 4 Removal and replacement procedures
Downloaded from LpManual.com Manuals
To Next Page
Loading...
