Remove the switch cover and keyboard:
1.
Remove the following:
(1) Four Phillips PM2.5×9.0 screws that secure the switch cover to the computer
(2) One Phillips PM2.5×9.0 screw that secures the keyboard to the computer
(3) Six Phillips PM2.5×5.0 screws that secure the switch cover to the computer
2.
Turn the computer right-side up, with the front toward you.
3.
Open the computer as far as possible.
4. Lift the left and right sides (1) of the switch cover until it disengages from the computer.
5. Release the switch cover (2) by sliding it back until it rests on the display bezel.
Component replacement procedures 47
Downloaded from LpManual.com Manuals
To Next Page
Loading...
