Compaq Presario V3500 - Page 106

d.
Switch cover (see
Switch cover on page 69)
e.
Display assembly (see
Display assembly on page 71)
f.
Top cover (see
Top cover on page 80)
g.
Wireless switch board (see
Wireless switch board on page 85)
h.
Audio board (see
Audio board on page 88)
i.
Bluetooth module (see
Bluetooth module on page 89)
j.
USB board (see
USB board on page 90)
k.
System board (see
System board on page 95)
Remove the ExpressCard assembly:
1.
Turn the system board upside down, with the RJ-45 connector toward you.
2. Lift the insulation material (1) from the system board to expose the ExpressCard assembly rear
screws.
3. Remove the four Phillips PM2.0×4.0 screws (2) that secure the ExpressCard assembly to the system
board.
4.
Turn the system board right-side up, with the RJ-45 connector toward you.
98 Chapter 4 Removal and replacement procedures