Remove the fan/heat assembly:
1.
Disconnect the fan cable from the system board.
2.
Turn the system board upside down, with the external monitor port toward you.
3. Loosen the four Phillips PM2.0×13.0 captive screws (1) that secure the fan/heat sink assembly to
the system board.
NOTE: Due to the adhesive quality of the thermal material located between the fan/heat sink
assembly and system board components, it may be necessary to move the fan/heat sink assembly
from side to side to detach the assembly.
4. Remove the fan/heat sink assembly (2).
NOTE: The thermal material must be thoroughly cleaned from the surface of the fan/heat sink
assembly (1) and the processor (2) each time the fan/heat sink assembly is removed. Thermal pads and
thermal paste must be installed on all surfaces before the fan/heat sink assembly is reinstalled. Thermal
pads and thermal paste are included with all fan/heat sink assembly, system board, and processor spare
part kits.
Component replacement procedures 101
To Next Page
Loading...
