ComXim MT Series - Page 18

MT series remote control intelligent turntable user guide
Copyright reserved by Shenzhen ComXim Technology Co., Ltd. 2017
17
event or report back, then enter the heart lost state, then every interval 1s send string ### inform
equipment heartbeat lost.
8.2.1 CT command（Terminal->Eequipment）
8.2.1.1 Base command
Format
Paramete
rs number
Meaning
CT();
0
CT Startup Test
CT+ACK(onOff);
1
Feedback switch (Enabled by default)
OnOff:
0: turn off
1: turn on (default)
CT+EVENT(onOff);
1
Event switch (Enabled by default)
OnOff:
0: turn off
1: turn on (default)
CT+HEARTBEAT(onOff);
1
Heartbeat switch (enabled by default) for link detection
OnOff:
0: turn off
1: turn on (default)
CT+IRDISABLE(onOff);
1
Infrared remote controller to enable switch
OnOff:
0: no (not to enable)
1: yes (to enable)
CT+SPKMUTE(onOff);
1
Turntable mute switch
OnOff:
0: not mute (default)
1: Mute
CT+SAVECONF();
0
Save device configuration, keep content as follows:
Turntable parameters:
1. Direction: 0: turn left (clockwise), 1: turn right (counter clockwise)
2.rotation mode: 0: continuous, 1: intermittent, 3: swing
(temporarily not supported)
3.automatic shutter: 0: non automatic, 1: automatic
4.rotation angle: rotation angle (positive floating point, degree)
5.pause time: positive integer, second
6.repeat number: positive integer, times
7.rate level: positive integer (the rate will maintain the maximum rate
if over the maximum rate of the turntable)