MT series remote control intelligent turntable user guide
Copyright reserved by Shenzhen ComXim Technology Co., Ltd. 2017
5
Figure4 TurntableX Software icon
5.2.2 Computer and turntable with WIFI version connection（Product support with "W"
in the name of the model）
Taking the following Windows PC software to connect MT200RUWSL10 devices as an example,
Introduce the steps of software application.
Attention：If you are using this software for the first time, or have not installed the WIFI driver, please
install the driver first. If the computer does not have a WIFI network card and the purchase device is not
equipped with the USB WIFI network card, please ensure that you have the WIFI network card and then
use the MTxxxW series turntable.
The following introduces how to use WIFI to control MTxxxW series turntable in Windows environment.
Insert the USB WIFI network card into the computer USB interface (using the built-in WIFI network card) and
install the driver according to the requirements。Electrify the WIFI turntable of MTxxxW series or other series of
ComXim company.（Explain：The computer comes with WIFI card, if you don't use the network card, you can also
use the computer to bring your own WIFI network card, if you connect the turntable, you need to use the WIFI
network, should have dual WIFI network card）。
First Step: Find WIFI hotspots
As shown in the diagram below, when the WIFI works properly, the turntable turns on power for 10 seconds，
Click on the network connection icon in the lower right corner of Windows，You can see the software search
"MT200RUWSL10", if the target device is not found, click on the icon ( ) to refresh.
To Next Page
Loading...