OPERATING THE STEAMER
1. Make sure the On/Off switch is in the
"0" (OFF) position.
2. Make sure all hose connections are
secure and tight.
3. Make sure the telescopic pole is fully
extended and the hose is not twisted,
kinked, damaged or cracked.
4. Plug the steamer cord into a normal
electrical outlet.
5. Push the main On/Off switch at the
base of unit to turn "I" (ON) .
6. The light will go on to indicate power is
on.
7. Steam will be produced from the
nozzle in about 100 seconds.
8. To turn the steamer off, push the On/Off
switch again.
9. Clean water tank easily
by removing cap at bot-
tom. Flush and clean as
needed. Empty the tank
when unit not in use.
Bristle brush attachment
Creaser Attachment
bottom
ATTACHMENTS
Both bristle brush and creaser attachments
easily snap on and off the steam nozzle.
Simply line up at base of nozzle and push
firmly to attach.
To Next Page
Loading...
Need help?
General
