Conceptronic EMRICK12B - Page 3

English
Congratulations on the purchase of your Conceptronic EMRICK12B.
When problems occur, we advise you to visit our support site (go to www.conceptronic.net
and click on 'Support'). If you have other questions about your product and cannot find it on
our website, please contact us at support@conceptronic.net.
For more information about Conceptronic products, please visit the Conceptronic website:
www.conceptronic.net.
Installation & usage
◼ Turn Off the power to your computer.
◼ Unplug the power cord and remove your computer’s cover.
◼ Remove the slot bracket from an available PCIe slot.
◼ To install the card, carefully align the card’s bus connector with the selected PCIe slot on
the motherboard. Push the board down firmly.
◼ Replace the slot bracket’s holding screw to secure the card.
◼ Replace the computer cover and reconnect the power cord.
Your computer will show the “New Hardware Wizard” on your screen. You can ignore this
“New Hardware Wizard” by clicking “Cancel”.
◼ Insert the CD-ROM in the optical drive of your computer. The AutoPlay option will be
shown automatically. Click on “Run Autorun.exe” to start the autorun menu.
◼ Select “Install Drivers” and follow the onscreen instructions to install the required
drivers for the serial PCIe card.
◼ When the driver installation is complete, restart your computer to ensure the drivers are
correctly loaded.
Safety & Warnings instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
◼ Keep the device away from water, humidity, fire or hot environments.
◼ Keep your device and all its parts and accessories out of the reach of small children.
◼ Do not leave the packaging material lying around carelessly. This may become
dangerous playing material for children.
◼ Avoid dropping, throwing or crushing the device.
◼ Do not open, change or damage the device.
◼ Disconnect the product from the mains before cleaning.
◼ Clean the product with a dry, fibre-free cloth.
Disposal of waste electrical equipment: Dispose of the product at a
recycling point. Do not dispose of together with household waste. Incorrect
storage/disposal can harm the environment and/or cause injury.
CE / UKCA marking: Conceptronic declares that this product
complies with the directives listed in the section 'Declaration of
Conformity'.