1 | Modbus Installation
Disconnect main power before any servicing.
The plumbing and electrical compartments contain high voltage components and
wiring. Access should be limited to authorized personnel only.
During and following operation of the humidifier, the steam and components in
contact with the steam such as the blower pack, steam lines, steam distributors,
and condensate lines can become hot and can burn if touched.
Condair Group AG does not accept any liability for installations of humidity
equipment installed by unqualified personnel or the use of
parts/components/equipment that are not authorized or approved by Condair
All electrical work should be done according to local and national electrical code.
Electrical connection to be performed by a licensed electrician.
Do not mount on hot surfaces.
Do not mount in area where freezing can occur.
Do not mount on vibrating surface.
Do not mount on floor.
Regardless of selecting on/off or modulating control method, Condair humidifiers
must have a closed circuit across its on/off security loop control terminal to
operate. Condair highly recommends the use of a duct high limit humidistat.
To Next Page
Loading...