(Figure D)
(Figure A and B)
(Figure E)
(Figure C)
STEP I. TURN THE LAMP SHADE TO THE DESIRED
POSITION (FIGURE A AND B).
STEP II. ADJUST THE HEIGHT OF THE LAMP;
HEIGHT CAN BE ADJUSTED BETWEEN 14.5”
AND 16.5“.
1. To adjust the height of the lamp -- Loosen the
thumbscrew at the back of the lamp (Figure C)
2. Adjust to the desired height (Figure D)
3. Tighten the thumbscrew to secure the lamp
height in place.
STEP III. PLUG THE ADAPTER CONNECTION INTO
THE BACK OF THE LAMP BASE (Figure E).
STEP IV. PLUG THE POWER ADAPTER INTO A
WALL OUTLET.
STEP V. LIGHT CONTROLS: THE ON/OFF TOGGLE
SWITCH IS PRE-INSTALLED ON THE LAMP
SHADE. SIMPLY TOGGLE THE TOGGLE SWITCH
TO TURN THE LAMP ON OR OFF.
LAMP USAGE
™
COPYRIGHT © CONOCO WEB 2013
CONOCO WEB, INC.
42 Corporate Park, Suite 250
Irvine, CA 92606
Phone: 1-888-783-0378
www.conocoweb.com
The information contained in this document is subject to change without notice.
To Previous Page
Loading...