12 49-3000336 Rev 0
Care and Cleaning
CARE AND CLEANING
Exterior of the Washer
Immediately wipe off any spills with a damp cloth.
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during servicing.
Service personnel – DO NOT contact the following parts while the appliance is energized: Drive Motor, Lid Lock,
Water Valves, Drain Pump and Recirculation Pump.
- Electrical Shock Hazard
WARNING
Separate for cleaning
Cleaning the Fabric Softener Dispenser
1
Remove the dispenser from the top of the agitator.
2
Separate the dispenser cup from the cover by grasping the top and pushing down on the inside of the
cup with your fingers. Dispenser cup will pop free from the cover.
3
To clean the dispenser, soak both the dispenser cup and the dispenser cover in the following solution:
■
1 US gallon (3.8 liters) warm water
■
1/4 cup (60 ml) heavy-duty liquid detergent
■
1 cup (240 ml) bleach
4
If necessary, loosen buildup with a clean, soft cloth after soaking. Do not use a stiff brush; you may
roughen the surface of the dispenser.
5
Rinse and reassemble dispenser. Place dispenser back on the agitator.
Interior of the Washer
Leave the lid open after washing to allow moisture to
evaporate. If you want to clean the basket, use a clean soft
cloth dampened with liquid detergent; then rinse.
(Do not use harsh or gritty cleaners.)
To Next Page