Need help?Do you have a question about the Consilium Salwico ST600EX-IR and is the answer not in the manual?
Introduces the purpose and products covered by the calibration instructions.
Outlines the necessary steps and conditions before starting the calibration process.
Details the steps for performing the zero calibration of the sensor.
Explains the procedure for conducting the span calibration of the sensor.
Describes the process for re-enabling detectors that were previously disabled.
General| Device Type | IR Flame Detector |
|---|---|
| Storage Temperature | -40°C to +85°C |
| Humidity | 0-95% RH (non-condensing) |
| Ingress Protection | IP66 |
| Power Supply | 18-32 VDC |
| Output | Relay |
| Material | Stainless steel |
| Weight | Approx. 2.5 kg |
| Certifications | ATEX, IECEx, FM |
| Housing Material | Stainless steel |
| Protection Rating | IP66 |
To Next Page