CONSTRUCTA Dishwasher - Switching salt and water softener settings; Salt indicator and water softener control

en
15
Switching the salt refill
indicator / water softening
system off and on
Close the door
Rotate the programme selector
3
from the 12 o’clock position by one
notch to the left.
Switch on main switch
1
and hold
down for at least 3 sec.
The digital display
8
indicates the
current set hardness value and the salt
refill indicator
6
flashes
(hardness value has been set to 4
at the factory).
To change the setting: Rotate the
programme selector
3
.
You can select a set value between
0 and 7 according to the hardness
of your water.
Switch off the main switch
1
.
The chosen setting has now been
stored.
Note
If you use the detergent and rinse aid
separately or switch from combined
detergents to standard cleaning products,
ensure that the rinse aid refill indicator has
been switched on and the water softening
system has been set to the correct water
hardness.