To identify the 3-digit Audio code, press
[
AUDIO
]
,
then
[
SELECT
]
in step 1, then press
[
INFO
]
.
To reset your remote control to its factory default
settings...
1. Press
[
CBL
]
, then
[
SELECT
]
together-hold both
down until the
[
CBL
]
illuminates.
2. Press
[
SETTINGS
]
, then
[
SETTINGS
]
again. The
[
CBL
]
button will blink and go out.
18. Helpful Tips and Troubleshooting
1. Your remote is equipped with a Point and Press
TM
Programming label on the back of its case. This
will help you quickly program the remote without
using codes.
2. An illuminated mode (power) button will remain
on while the remote is in a programming mode. In
the absence of an entry, the illuminated button will
go out after 45 seconds.
When locking in your devices, the illuminated
button will blink and go out,
3. When using the Point and Press
TM
programming
method, you may find a code that turns your
device off but not back on. If this happens...
a.the correct code has not been found. Continue
pressing
[
CH
+
]
until your devices turn on and
off.
OR
b.you may have gone past the correct matching
code. Try pressing
[
CH
–
]
one
press at a time
until you find a code that turns your devices turn
back on.
4.If the same button is pressed and held for 45
seconds, your remote control will turn itself off.
This extends the battery life by should the remote
become lodged under or between heavy objects.
5. For diagnostic functions on Motorola (GI) DCT
and CFT2200 cable set-top terminal, press
[
SELECT
]
+
[
INFO
]
together.
6. If you have any questions concerning the operation
of your cable set-top terminal, contact your cable
operator.
To Previous Page
Loading...