Standard Practice Maintenance Manual 1-11
30 Sep 2016 CHANGE 2
Introduction
1-2.4.1. Service Documents Incorporated in this Manual
Applicable technical maintenance and service information contained in the Service
Documents listed below, relevant to the engine models covered by this engine manual,
have been incorporated in this M-0 Standard Practice Maintenance Manual. This manual
supersedes and retires these older Service Documents (where applicable) excluding
Mandatory Service Bulletins (MSBs) and Critical Service Bulletins (CSBs) identified
with an asterisk below.
The full content of active Continental Motors Service Documents is available at
www.continentalmotors.aero. Refer Section 1-3, “Contact Information” for Continental
Motors web site details.
Table 1-1. Service Documents Incorporated in Manual
Service Document Subject Affected Chapter
M67-12, Overboost of Turbocharged Engines Unscheduled Maintenance 6
M72-17R1, Maximum Weight Difference Between
Connecting Rods and Pistons in the Same Engine
Parts Replacement 10
M76-4, Propeller Shaft or Crankshaft Oil Seal
Replacement
Unscheduled Maintenance 10
M76-8, Intake Valve Change Unscheduled Maintenance 10
M77-3, Use of Alternate Fuels in Engines Originally
Certified for 80/87, 91/96 and 100/130 Grade Fuels
Engine Operation 7
M84-5, Gear Driven Alternator Inspection Procedure Alternator Replacement 10
M87-15, Alternator Ground Strap Alternator Replacement 10
M88-9, Lightning Strikes Unscheduled Maintenance 6
M88-10, Contaminated Fuels Unscheduled Maintenance 6
M89-7R1, Engine Operation after Cylinder
Replacement and/or Major Overhaul
Unscheduled Maintenance 7
M89-9, Excessive Crankcase Pressure Unscheduled Maintenance 8
M90-17, Crankcase Inspection Criteria Scheduled Maintenance 6
SIL93-11B, Service Document Format Service Documents 1
SIL93-15, General Practices for Installation of Lock
Wire, Tab Washers, and Cotter Pins
Standard Practices Appendix C
* MSB94-8D, Magneto to Engine Timing Scheduled Maintenance 6
SB95-2, Inspection and Maintenance of Engine Control
Cables and Linkage
Inspection 6
SB95-3B, Alternator/Generator Drive Coupling Alternator Maintenance 6, 10
SIL95-5, Hose and Tubing Installation Hose and Tubing installation Appendix C
SB96-7D, Torque Limits Fastener Torque Appendix B
* MSB96-10B, Crankshaft Ultrasonic Inspection Engine Overhaul or Crankshaft
Repair
10
SB96-11B, Propeller Strikes and Hydraulic Lock Unscheduled Inspection 6