REACH-IN
FREEZER
FREEZERS
Utilizing Environmentally Safe, CFC-free R-404A Refrigerant
Standard Features
• Modern, State-of-the-Art Styling
• Performance rated “Plug” Refrigeration System
Utilizing Environmentally Safe R-404A Refrigerant
Designed for (0°F) Cabinet
• 3" Non-CFC Polyurethane Foam Insulation
• Cam-Action Lift-Off Hinges
• Self-Closing Doors
• Magnetic Snap-In Door Gasket
• Cabinet Upper Side Panels And Refrigeration
“Plug” System Can Be Easily Removed and
Reinstalled At Job Site Where Space Limitations
are Confining
• Cylinder Lock In Each Door
• Automatic Hot Gas Condensate Evaporator
• Refrigeration System is Readily Accessible on Top
of the Cabinet and Separate from the Food Zone
to Increase Food Storage Capacity
• Adjustable 6" Stainless Steel Legs
• Heavy-Duty, Epoxy-Coated Steel Shelves
• External Digital Thermometer
• Automatic Electric Defrost
• Fluorescent Interior Lighting
Models Available
• Half Door • Pass-Thru
• Remote • Consult Factory
Standard (S/S Front, Aluminum Ends & Interior)
Suffix SA (S/S Exterior, Aluminum Interior)
Suffix SS (S/S Exterior & Interior)
DL2F-SS
DL3F-SS
DL1F-SS
Refrigeration System
A “performance rated”, air cooled, hermetically
sealed, capillary-type refrigeration system is installed
on the top of each freezer. Plasticized fin coil and air
circulating fans are contained within a concealed
“plug” type insulated housing, readily accessible on
the top of the cabinet and separate from the food
zone to increase food storage capacity. The entire
“plug” system is fully charged with refrigerant and
mounted on a sturdy steel, rail-type base which can
be easily removed if refrigerator conversion is
desired. Freezers are designed to maintain 0 degrees
Fahrenheit (-18 degrees Centigrade) while operating
with an unrestricted air supply in a maximum ambient
temperature of 100 degrees Fahrenheit. Automatic
electric defrost timer initiates defrost cycles at prede-
termined intervals. All condensate water is evaporat-
ed by an automatic non-electric, corrosion-resistant
condensate evaporator. A strict quality-assurance
team inspects all materials and components to certify
that each model conforms to the most exacting stan-
dards. All models are factory performance tested for a
minimum of 16 hours prior to crating.
Cabinet Construction
All materials are of top quality, assembled to conform
with strict quality-assurance requirements. The cabi-
net front is constructed of heavy-gauge polished
stainless steel for durability. All cabinet joints and
seams are sealed vapor-tight. Case is of all metal,
welded construction and internally supported and
braced for a rigid unit construction. Cabinet design
eliminates overlapping panels with raw edges.
Cabinet body is insulated with non-CFC, foamed-in-
place polyurethane foam with an average thickness of
3 inches to ensure increased energy efficiency. Full-
length louvered air grille located above the doors
allows equal air circulation to the condensing unit.
Easily removable, low wattage, anti-sweat door
heaters concealed by a non-metallic, non-conductive,
high impact thermal breaker strip eliminates conden-
sate build-up on the cabinet front. Fluorescent lighting
is activated by an easily accessible interior switch.
Cabinets are equipped with 6-inch adjustable stain-
less steel legs.
Shelving
Shelves are designed for heavy-duty use with .306"
diameter frame and brace members and .140" diam-
eter fill wires spaced 3/4" apart. Shelves are welded
steel and epoxy-coated for a durable, long, rust-free
service life. Adjustments are in 1/2" increments and a
wide door opening allows the use of a variety of
optional pan and tray slide types.
Door Construction
Door shells are constructed of heavy-gauge stainless
steel and are internally braced and urethane-foam -
insulated for rigidity.
Door corners are of welded
construction and polished. Replaceable snap-in
door gaskets are self-adjusting, heavy-duty, mag-
netic type. Door handles and hinges are chrome-
plated and non-corrosive. Doors are provided with
built-in cylinder locks which are keyed alike.
Hinges are cam-action, lift-off type featuring posi-
tive safety stop at 120 degrees.
To Next Page
Need help?
General
