audible scienceaudible science
page 50
INSTALLATION & SETUP CONT.
HOW TO ADJUST THE AZIMUTH cont.
They are located at right angles to the azimuth adjusting
sapphire ring holder.
If you look at the arm from the front on you will see a
brass coloured secondary pivot on the right hand side (at
the rear of the arm where the main pivot is).
This is the secondary pivot that rests on the sapphire
ring. By raising or lowering the sapphire ring you will
adjust the azimuth by means of this secondary pivot.
If we view the cartridge front-on from the headshell as
an indicator for the direction of azimuth, the following
applies: winding the sapphire ring down (clockwise) the
right hand side of the cartridge will dip down.
Winding the sapphire ring up (anticlockwise), viewed
front-on, the left hand side of the cartridge will dip down.
There are a series of small dashes and dots on the
azimuth adjuster.
INSTALLING
& TUNING
YOUR COBRA
To Next Page
Loading...