6
5. Refit the Chopper Lid. Align with the marks and then rotate clockwise to lock.
6. Place the assembled Chopper Bowl on a flat, level and stain resistant surface.
7. Attach the Blender Body into the top of the Chopper Bowl and twist clockwise to lock.
WARNING: Maximum operating time cannot exceed 30 seconds and 3 minutes rest
time. This can be repeated a second time.
8. To operate your Cordless Blender, proceed as follows:
9. To Switch ON the Cordless Blender, press the Safety Interlock Button (3) and
then Power ON/OFF Button (4). Once the Blender is operating you can release the
Safety Interlock Button. (If you release the Power ON/OFF Button then you will
need to repeat the two-button process again). When operating the Indicator (1) shows
BLUE. If your battery becomes low then it changes to RED.
NOTE: Pulsing ON – OFF often achieves the best results.
10. When you have finished using your Blender remove the Body from the Chopper
Bowl by twisting it Anti-clockwise.
WARNING: DO NOT remove the lid from the Chopper Bowl with the Blender still
attached. Safety hazard.
11. Disassemble and clean, see the Cleaning Section for guidance.
SAFETY INTERLOCK BUTTON (3)
POWER ON/OFF BUTTON (4)
To Next Page
Loading...