How to Adjust the Ventilation System
There are two sliding actuators in the front of the chinbar. Figure 9.
1. The ventilation that is directed toward the inside surface of the visor to aid in reducing fogging Air Flow A
2. The ventilation that is directed towards your mouth. Airow B
We advise that the upper vent slider Air Flow A is always in the open position when used for skydiving
specic activities Figure 10.
The Liner
Your G4 helmet features an unique liner. This liner can be replace
.Please visit www.ycookie.com for instructions on removing
and replacing your liner.
Caring for your G4 Helmet
Your G4 Helmet should be cleaned using water, mild detergent and a soft cloth. Ammonia and acid based
cleaning products should not be used at all. Any use of paints or adhesives can damage the exterior of the
helmet and reduce the helmets ability to provide protection. Please store your helmet away from direct
light or heat source as this can damage the helmet. When traveling we recommend using the helmets
original packaging.
An impact to the G4 helmet can cause damge even if there are not any visible signs. A damaged helmet
will not protect you against further impacts. If you suspect the helmet to have been damaged it must be
replaced immediately.
We recommend replacing your helmet afer every three years of use as we cannot guarantee that it will
oer sucient protection after this period. You must also replace your helmet if it is showing signs of
Cracking, Peeling and any Deformation. Childrens helmets should be replaced once they no longer t
Your should Always
1. Wear your G4 helmet low over your forehead and the chinstrap beneath your chin.
2.
Fasten your buckle and ensure the neck curtian is tight around the rear of your head and neck.
Adjust the Anchor Cord if required.
3. Make sure these adjustments are correct prior to use.
4. Store your helmet in a cool and dry place.
5. Replace your G4 helmet after and accident, even if no damage is shown.
6. Ensure the visor is tted and closed when wearing it for Skydiving or Flying in a Wind Tunnel.
7. Ensure your visor is clean befor use and replace it if it is dicult to see through or if the lens
begins to fog.
Your should Never
1. Wear a helmet that has been in an accident, even if no damage is shown.
2.
Wear a helmet with an unfastened chinstrap or if the neck curtain is loose around the rear of your head.
3. Wear this helmet for any activities that is not Skydiving or Wind Tunnel ying.
4. Clean this helmet with Chemical Cleaners.
5. Fit any non Cookie Composites accessory to the helmets shell.
Installing the Audible Altimeter
Install your audible altimeter into the pocket located over each ear
Figure 11.
Figure 9.
How to Open your G4 Visor
Place your index nger in position A on the top of visor locking plate
and your thumb on the bottom position B. Next you will need to push
the visor locking plate in the forward direction unlocking the mechansim.
Once you have moved the visor locking plate forward 9mm or 3/8 .inch [•)
you can now begin to rotate the visor locking plate in an upward direction.
It is best to do this with the G4 on your head. It may take a couple of tries to
perfect the movement and holding your elbows upwards in line with your
shoulders can assist with this movement. To close the visor, simply hold the
top of the visor and rotate downward. The visor will make a loud sound as it locks
into place and the springs return the visor to the locked position.
HELMET OWNER’S MANUAL
English
HELMET OWNER’S MANUAL
English
Figure 10.
A
A
B
A
Figure 11.
HELMET OWNER’S MANUAL
English
Figure 11.
Installing the Audible Altimeter
Install your audible altimeter into the pocket
located over each ear Figure 11.
The Liner
Your G4 helmet features an unique liner.
This liner can be replaced. Please visit
www.flycookie.com for instructions on
removing and replacing your liner.
Your should Always
1. Wear your G4 helmet low over your forehead
and the chinstrap beneath your chin.
2. Fasten your buckle and ensure the neck
curtain is tight around the rear of your head
and neck. Adjust the Anchor Cord if required.
3. Make sure these adjustments are correct
prior to use.
4. Store your helmet in a cool and dry place.
5. Replace your G4 helmet after and accident,
even if no damage is shown.
6. Ensure the visor is fitted and closed when
wearing it for Skydiving or Flying in a
Wind Tunnel.
7. Ensure your visor is clean befor use and
replace it if it is difficult to see through or if
the lens begins to fog.
Your should Never
1. Wear a helmet that has been in an accident,
even if no damage is shown.
2. Wear a helmet with an unfastened chinstrap
or if the neck curtain is loose around the rear
of your head.
3. Wear this helmet for any activities that is not
Skydiving or Wind Tunnel flying.
4. Clean this helmet with Chemical Cleaners.
5. Fit any non Cookie Composites accessory to
the helmets shell.
Caring for your G4 Helmet
Your G4 Helmet should be cleaned using water,
mild detergent and a soft cloth. Ammonia and
acid based cleaning products should not be
used at all. Any use of paints or adhesives can
damage the exterior of the helmet and reduce
the helmets ability to provide protection.
Please store your helmet away from direct light
or heat source as this can damage the helmet.
When traveling we recommend using the
helmets original packaging.
An impact to the G4 helmet can cause
damage even if there are not any visible signs.
A damaged helmet will not protect you
against further impacts. If you suspect the
helmet to have been damaged it must be
replaced immediately.
We recommend replacing your helmet
after every three years of use as we cannot
guarantee that it will offer sufficient protection
after this period. You must also replace your
helmet if it is showing signs of Cracking,
Peeling and any Deformation. Childrens
helmets should be replaced once they no
longer fit.
6 7
To Next Page
Loading...