HELMET OWNER’S MANUAL
English
Removal for Cleaning or Replacement
Cleaning:
Always keep your visor clean. Dirt and Grease
can form a barrier layer over the anti-fog
coating applied to the inside surface of the
visor and this can dramatically reduce its ability
to prevent fogging.
We do recommend replacing your visor
periodically if fogging starts to occur. Generally
every 6 months with frequent use.
We recommend cleaning your visor with a
pH neutral soap and water to remove any build-
up of grease and dirt.
Do not use any abrasive materials or chemical
solvents when cleaning your visor as this will
damage the anti-fog coating.
Removal:
With the visor in the closed position, undo the
two. visor side plate screws on each of the side
plates using a Star Screwdriver. (See 1)
Remove the side plates. (See 2)
Slide the Visor Forward. (See 3)
To replace. Slide the visor back into
position with the visor tabs going behind the
mechanism. (See 4)
Align the Side Plate with the Locking
mechanism and assemble the two screws.
WARNING – DO NOT OVER TIGHTEN THE SIDE
PLATE SCREWS.
8 9
To Next Page
Loading...