Issue 2 28/09/2021 5
TO USE
1. Clean thoroughly before use.
2. Place the motor housing on a stable surface, check that the
speed switch is at the off (0) position, fully unwind the cable
and plug in.
3. Place the ingredients to be blended into the jug and check
that the level is not above the maximum level marked
(1500ml).
4. Fit the lid and stopper to the
jug and lock into position (figs.
1). When the lid is correctly
fitted the silver tab will be
aligned with the jug handle.
5. Fit the jug onto the base, align
the arrow marked on the jug
with the ‘unlocked’ padlock
symbol on the side of the motor
housing and twist until it is
aligned with the ‘locked’
symbol (figs. 2).
6. Using the speed switch, select
the appropriate blender speed
for your ingredients. A slower
mix will be obtained by
selecting the lower speed
setting (1) and a faster mix by
selecting the higher setting (2).
7. If the blender does not operate
check that the jug and the lid is
fully locked into position.
To Next Page
