Coolbox H309 User Manual

- Volume up/down (Up switch the button mean volume+;the headset will make a beep if the
volume are on full blast; Down switch volume-,the headset will also make a beep if the volume
are on min.).
- Previous/Next (press the button up/down for long time)
- Play/pause (When on the music state, press button one time, the headset will be in Pause state;
press again, the headset will be in music state.)
5. LED light
Status indicator:
- Alternating red and blue LED indicate headset has entered into the pairing mode and ready to
be detectable for the first time.
- Blue LED flashing slowly indicates the device is powered on and /or connected.
- Solid red LED indicates the battery is charging.
II-Basic Operation
Charge your headset
- Use the supplied USB cable to charge the battery directly from your PC.
- Make sure that your CoolBox H309 headset is fully charged before using it for the first time.
- The headset battery has to be initially charged for at least for 4 hours.
- While charging, the LED is solid red. When the battery has reached full capacity, the solid red
LED will go off.
Turing your headset on and off
1. Press and hold the power button for several seconds to turn on the headset.
2. To power off the device, press and hold the power button again for a few seconds.
IV-Advanced operation
Note: Before installing this product, please make sure your computer or laptop has the available
built-in Bluetooth feature. If your computer is not Bluetooth-enabled, you must purchase a
Bluetooth dongle, preferably version 2.1 or above.
Pairing the headphones with your computer
1) Make sure the headset is on.
2) Activate the Bluetooth program in your computer to begin setup.
3) The “search new device” screen will be displayed.
4) Place both devices not more than one meter away from each other.
5) Press the power button on the headset to turn it on The blue and red LEDs will start
blinking in sequential order. This indicates that the headset has entered into pairing mode.
6) As soon as the system detects the new device in your dialog box, double click the icon
representing the headset.
7) The software connection will be established automatically with the remote device.
8) If the pairing is successful, the blue LED will start blinking slowly. If after 60 seconds the
pairing process fails, please repeat steps 1to 7 described above.
9) The headset will go automatically into standby mode after a short period of inactivity.

Coolbox H309 Specifications

General

Brand	Coolbox
Model	H309
Category	Headsets
Language	English