Need help?Do you have a question about the Coolster QG-210 and is the answer not in the manual?
Crucial safety warnings for operating the dirt bike, including age limits and protective gear.
Introduction and appreciation for selecting the OFF ROAD MOTOBIKE.
Advice on reducing speed when approaching corners and safe braking practices.
Warning about potential hazards when passing parked vehicles.
Contact details for warranty inquiries.
Identification of key motorcycle parts and components through diagrams.
Location and purpose of VIN and engine serial numbers for identification.
Explanation of the ignition switch and automatic clutch system.
Details on operating the rear brake pedal and fuel valve system.
Checks to perform on the vehicle before starting operation.
Guidelines for ensuring adequate fuel and avoiding spillage.
Procedure for checking the engine oil level at designated points.
Procedures for measuring oil and replacing the oil filter.
Instructions for checking tire pressure and inspecting for wear.
Steps for starting the engine from a cold state.
How to start the engine after it has been preheated.
Guidance on shifting gears and accelerating the vehicle.
Safety precautions when parking the dirt bike.
Schedule for routine maintenance tasks like lubrication and part checks.
Information on checking and tightening vehicle parts and fasteners.
Steps to adjust the engine's idle speed for optimal performance.
Maintenance and cleaning of the crankcase emission filter.
Guidance on inspecting, cleaning, and replacing air filters.
How to adjust the throttle cable for proper free play.
Procedure for inspecting the spark plug condition and gap.
Steps to adjust the free play of the front wheel brake lever.
How to adjust the free play of the rear brake pedal.
How to check and adjust the drive chain's slack.
Detailed steps for adjusting the tension of the drive chain.
Method for lubricating the drive chain for longevity.
Recommended lubricants for various shaft components.
How to properly wash and clean the dirt bike, with specific warnings.
Guidelines for storing the vehicle for extended periods.
Safety instructions for transporting the dirt bike.
Steps to prepare the dirt bike after a period of storage.
Procedures for unpacking and assembling the dirt bike from its packaging.
Steps for installing fenders, front shock absorbers, and wheels.
Details of the emissions-specific limited warranty for the vehicle.
Troubleshooting common problems related to starting and engine instability.
Troubleshooting problems like engine not starting, power loss, and shaking.
Key technical specifications including dimensions, engine details, and capacities.
Visual representation of the vehicle's electrical system.
Covers what is and is not included in the warranty, claim procedures, and policies.
Crucial safety warnings for operating the dirt bike, including age limits and protective gear.
Introduction and appreciation for selecting the OFF ROAD MOTOBIKE.
Advice on reducing speed when approaching corners and safe braking practices.
Warning about potential hazards when passing parked vehicles.
Contact details for warranty inquiries.
Identification of key motorcycle parts and components through diagrams.
Location and purpose of VIN and engine serial numbers for identification.
Explanation of the ignition switch and automatic clutch system.
Details on operating the rear brake pedal and fuel valve system.
Checks to perform on the vehicle before starting operation.
Guidelines for ensuring adequate fuel and avoiding spillage.
Procedure for checking the engine oil level at designated points.
Procedures for measuring oil and replacing the oil filter.
Instructions for checking tire pressure and inspecting for wear.
Steps for starting the engine from a cold state.
How to start the engine after it has been preheated.
Guidance on shifting gears and accelerating the vehicle.
Safety precautions when parking the dirt bike.
Schedule for routine maintenance tasks like lubrication and part checks.
Information on checking and tightening vehicle parts and fasteners.
Steps to adjust the engine's idle speed for optimal performance.
Maintenance and cleaning of the crankcase emission filter.
Guidance on inspecting, cleaning, and replacing air filters.
How to adjust the throttle cable for proper free play.
Procedure for inspecting the spark plug condition and gap.
Steps to adjust the free play of the front wheel brake lever.
How to adjust the free play of the rear brake pedal.
How to check and adjust the drive chain's slack.
Detailed steps for adjusting the tension of the drive chain.
Method for lubricating the drive chain for longevity.
Recommended lubricants for various shaft components.
How to properly wash and clean the dirt bike, with specific warnings.
Guidelines for storing the vehicle for extended periods.
Safety instructions for transporting the dirt bike.
Steps to prepare the dirt bike after a period of storage.
Procedures for unpacking and assembling the dirt bike from its packaging.
Steps for installing fenders, front shock absorbers, and wheels.
Details of the emissions-specific limited warranty for the vehicle.
Troubleshooting common problems related to starting and engine instability.
Troubleshooting problems like engine not starting, power loss, and shaking.
Key technical specifications including dimensions, engine details, and capacities.
Visual representation of the vehicle's electrical system.
Covers what is and is not included in the warranty, claim procedures, and policies.
General| Brand | Coolster |
|---|---|
| Model | QG-210 |
| Category | Motorcycle |
| Language | English |
To Next Page
