Cooper Scantronic 9 5 Series User Manual

3. Testing Commands
497096, Issue 6 Page 71
Keypad Display Printed (9853 only)* Meaning
Bell Tamper Bell Tamper Sounder tampered with
Bell Tamper Rst Bell Tamper Restore Sounder tamper reset
Burg Z== Alarm Burg: Z== Intruder alarm on zone ==
Burg Z== Rstr Burg Restore Z== Intruder alarm on zone == reset
Bypass Supr. Z== U== Sup. Bypass Z== Supervision on zone == bypassed
Codes Defaulted Passwords Loaded Access codes returned to default values
Comms Fail Comms Fail Communications failure (e.g. no response
from ARC)
Config Changed Config Changed System configuration (site-specific data)
has changed
Defaults Loaded Defaults Loaded Default values loaded for all commands
EEPROM Fail EEPROM Bad Data Control unit memory damaged
Exp == Tamp Rst Exp. Tamper Restore Expander tamper reset
Exp == Tamper Exp. Tamper Expander tampered with
Expander == Miss Expander Missing Expander disconnected
Expander == Rstr Expander Restored Expander reconnected
F== Missing Forbi Missing F== Forbikobler keypad disconnected
F== Restore Forbi Miss Restore F== Forbikobler keypad reconnected
F== Tamper Forbi Tamper F== Forbikobler keypad tampered with
Fire Reset U== Fire Reset Fire alarm reset
Fire Z== Alarm Fire Z== Fire alarm on zone ==
Fire Z== Rstr Fire Restore Z== Fire alarm on zone == restore
Forbi I/F Tamper Forbi I/F Tamper Forbikobler interface tampered with
Forbi Lp Tamper Forbi Lp Tamper Forbikobler loop tampered with
Fr K== Alarm K/P Fire K== Fire alarm started at keypad ==
Frb I/F Tamp Rst Forbi I/F Tamp Restore Forbikobler interface tamper reset
Frb Lp Tamp Rst Forbi Lp Tamp Restore Forbikobler loop tamper reset
Global T.Restore Global T.Restore Global zone tamper alarm reset
Global Tamper Global Tamper Global zone tamper alarm
K== Excess Keys Tamper Usercode K== Incorrect access code entered more than
four times at keypad ==
K== Missing K/P Missing K== Keypad == disconnected
K== Restore K/P Miss Restore K== Keypad == reconnected
K== Tamper Tamper K/P K== Keypad == tampered with
Key Box Cls Z== Keybox Close Z== Keybox on zone == closed
Key Box Opn Z== Keybox Open Z== Keybox on zone == open
Key Sw Set # Key Switch Set # System set by keyswitch on level/partition
#
KeySw Unset # Key Switch Unset # System unset by keyswitch on
level/partition #
Lid Tamp Restore Lid Tamp Restore Control unit lid tamper reset
Lid Tamper Lid Tamper Control unit lid tampered with
Low Bat Z== Tx Lo Batt Z== Low battery detected on transmitter ==
Low Bat Z== Rstr Tx Lo Batt Restore Z== Low battery reset on transmitter ==

Cooper Scantronic 9 5 Series Specifications

General

Brand	Cooper
Model	Scantronic 9 5 Series
Category	Control Unit
Language	English