BEFORE USE
Remove the
battery
compartment
cover. Insert 1xAA
battery, observing
correct polarity as
indicated in the
battery
compartment.
Replace the battery compartment cover.
SETTING THE CLOCK
The clock automatically sets itself to 12 o’clock and
searches for the R/C signal. Once it has received the MSF
signal, the clock automatically displays the correct time.
We recommend that you do not put up or hang the clock
during this process.
If the clock still has not set itself after 12 minutes,
reception is faulty or the signal is not being received at the
chosen location. Repeat setting process at a different
location by pressing the RESET button.
SETTING/SNOOZING THE ALARM
• To set the time of the alarm, turn the set-alarm knob in
the direction of the arrow in order to set the alarm time.
Never turn the set-alarm knob in the opposite direction
to that shown by the arrow as this could damage the
works.
• To switch the alarm on, press the ON/Off switch. At the
set alarm time, the alarm sounds for maximum 2 minutes
providing the ON/OFF button is in the ON position and
the snooze button is not pressed.
• To snooze the alarm, press the snooze button on the top
of the alarm clock. The light turns on for 3-5 seconds. The
alarm is interrupted for 5 minutes and then sounds
again. The snooze function can be repeated 3-7 times.
Note: If the alarm is not interrupted or switched off, it will
stop automatically after approximately 2 minutes. It is
reactivated 12 hours later at the same time.
• To switch off the alarm, push the alarm ON/OFF button
down.
To be able to read the clock face when it is dark, briefly press
the button on the top of the alarm clock to illuminate the
face. The illumination function is activated for 5 seconds.
To Next Page
Need help?
General