User Manual v1.2
11
Maintenance Of The Bridle Lines
These trim/set-up options are designed for the experienced
user. The bridling has to be partly taken apart and it is of ut-
most importance that the lines are re-connected and in the
right place.
Modifications on bridle settings happen on your own danger.
Hiss-Tec Fehmarn assumes no liability!
The GT has some bridle tuning points for the front bridle.
Using the point pointing to the middle of the kite will increase
kite feedback, using the point more to the tip will decrease bar
pressure.
The standard setup is the point in the middle.
Chickenstick
The picture shows the assembly of the Chickenstick. It has to be on the right
side of the chickloop (riders point of view) and then attached to the harness
hook.
Bridle Line Trim (experienced users only)
The bridle lines must be controlled and maintained before every usage of the kite. After using the kite, the lines should be
washed with fresh-water and checked for wear and tear. Sand must be removed completely.
We recommend to attach the front bridle attachment point to the back bridle attachment to avoid accidently twisting and
knotting of the bridle while packing the kite. Always check the pulleys for free movement!
To Next Page
Loading...