Installation and Service Manual
© 2004, IMI Cornelius Inc. - 9 - Publication Number: 710160089
WARNING: Melt ice bank completely, disconnect electrical power and the wiring harness quick
disconnect on the refrigeration deck before draining the water bath and attempting to remove the
refrigeration deck from the water bath or permanent damage to the deck or coil basket may
result.
The water bath compartment is well insulated and it may take five or six hours for the ice to melt.
Refilling with warm water may help to melt the ice more rapidly.
1. Remove plug from the drain tube (located under the drip tray) and position the tube to drain into the
drain pan.
2. After the ice has melted, remove the deck.
3. Thoroughly clean around all the coils and between all crevasses with a brush and cleaning solution
to remove all algae and foreign matter. Dry the water bath.
4. Clean the condenser with a vacuum cleaner or a soft bristle brush.
5. Clean compressor, agitator motor and fan assembly with a cloth, wiping off accumulated dust.
6. Place the refrigeration deck into its original position.
7. Replace drain tube plug and fill the water bath with clean cold water.
8. Reconnect the wire harness on the refrigeration deck.
9. Place cabinet top back onto the unit in its original position and secure.
10. Clean and sanitize product lines and valves per number 4 above before placing dispenser into
service.
To Next Page
Loading...