Cove DW2450 Manual

CONTENTS
Middle rack tine pair
TOOLS REQUIRED
None
REMOVE THE MIDDLE RACK
1 Open the door.
2 Pull the middle rack forward.
3 Remove the end caps on both rails by pulling the end
cap locking tabs outward, then pulling the end caps
off the rails.
4 Remove the middle rack from the unit.
REMOVE THE MIDDLE RACK TINES
1 Place the middle rack on a flat surface facing
upward.
2 For adjustable tines:
a) Use the green tabs to adjust the tines to the upward
position.
b) Pull upward on the middle and rear tine clips to raise
the rear of the tine pair.
The clips will come loose from the rack, but they will
still hold the tine pair together.
c) Remove the rear tine clip.
d) Lift the rear of the tine pair to angle it upward.
e) Pull the tine pair backward to remove it from the front
hub.
f) Remove the tine pair from the rack.
g) If necessary, separate the tines by removing the
middle tine clip.
Adjustable tines
3 For non-adjustable tines:
DW2450 and DW2450WS Middle Rack Tines
Replacement
www.coveappliance.com 800.222.7820
830857 REV. A 03/2022
Page 1 of 2
*830857$REV.$A*

Cove DW2450 Specifications

General

Style	built in
Color	panel ready
Number of Cycles	auto, normal, heavy, quick, pots and pans, soak and scrube, light, china/crystal, rinse/hold, plastics, energy, extra quiet; 12
Number of Options	6
Drying Type	heated
Noise level	41 db
Control Type	touch sensor
Delay Start	yes
Number of Racks	3
Spray Arms	3
Water Filter	yes
Water Softener	no
Food Disposer	no
Sanitize Settings	yes
Half Load	no
Wi-Fi	no; yes
Smart Home	no
Remote Control	yes
Voltage	115 volts
Frequency	60 hz
Current	15 a

Weight and Dimensions

Depth	23 1/4 inch
Height	34 1/2 inch
Width	23 5/8 inch