ENTRY DELAY
ACTIVE IN STAY MODE
SENSITIVITY
DETECTING PETS
TESTING SENSOR
CHANGING BATTERIES
12
Motion Sensors have a 0 second entry delay. It is recommended to keep the
Motion Sensors is protecting an area that is rarely used. To
Motion Sensors are set to high sensitivity to prevent false alarms. To change
Motion Sensors will not detect a body under 55 pounds. To change this setting
Motion Sensor’s signal to the panel, tap Settings > Motion Sensors > (select
Motion Sensors require one CR123A battery. Press in on the recessed tab at the bottom
After replacing the batteries it is recommended that you
test the sensor to make sure it works properly.
To Next Page
Loading...