INSTALLATION
1. Close main water supply valve to separate the faucet.
2. Wind the teon tape on the adaptor and t it to the pipe.
3. Connect the faucet with the adaptor.
4. Connect ¼ inch orange tubing with the connector
on the adaptor.
5. Connect it to a socket with voltage rating that matches the
one stated on the rating plate. Then, open the feed valve to
supply water to the ltration system.
Do not turn the water pipe.
Flush water through each lter at least 5 minutes
before connecting.
Please install the adaptor with connector on the
cold water pipe.
How to use
12
11
BUTTONS AND INDICATORS / INSTALLATION
To Next Page
Loading...
