Preparation for use
Ⅰ
Ⅲ
Ⅱ
Ⅳ
Install as per the following:
1
Connect the tap water supply adapter to the water valve.
2
Install inlet and drain lines on the body.
6
Connect the power plug of the main body.
7
If the water tray needs automatic drainage, you can install a drain hose of
the water tray.
3
Open the top cover and open the water tank cover to put the internal tank
cover over the cold water tank.
4
Connect the distance rod of the water tank cover to the bottom of the water
tank cover.
5
Close the water tank cover, insert the clip, and then close the top cover of
the main body.
To Next Page
Loading...
