HOW TO REPLACE THE FILTER
3. Hold the bottom of the lter you want to replace with one hand and raise the lock lever
upward to replace the lter.
4. Close the cover and turn the lever located to the right of the cover toward the outside to
lock it, then insert the side door into the slot. (If you do not turn the lever to close the door,
it will not be closed.)
▶
▶
Check that the lter is securely installed and that the lever is supporting it well,
then turn on the source water to check that there are no leaks.
We will replace ttings, tubings, and faucets after 5 years of use if you contact our
customer service center (this may incur a cost).
Please be sure to use the new lter after ushing.
- Neo-sense lter : Please assemble after ushing with tap water for 1 minute.
- Plus Inno-sense lter : Please use the lter without ushing.
- Membrane lter (RO) : Please assemble after ushing with Neo-sense lter for
about 5 minutes.
Tips
Tips
Tips
To Next Page
Loading...
