41
Tyres
Your tyres naturally wear over time
and need replacing. There is a
yellow Kevlar compound layer wear
indicator inside. When the tyre is
worn and the inner layer becomes
visible, it’s time for a new one. If you
need to replace the inner tubes,
choose any tube with a Presta valve
(aka F/V) compatible with the
following tyre dimensions (several
ways to define tyre sizes):
• 42-584 / 47-584
• 27,5”x1,65” / 27,5”x1,75”
- 650-42 / 650-48
If you can’t find tubes to fit those
dimensions, you may use smaller
ones such as:
• 559-47 or 26”x1,75
If you need to remove the wheels
for any reason, reassemble the
front wheel through the axle with
10Nm torque and the rear wheel
nuts with 35Nm. For guidance
speak with us in the app or check
our online tutorials.
Belt drive
For Performance models, the
carbon belt drive system does
not require lubrication. Applying
lubricant can cause the system
to malfunction.
Regularly inspect the belt and
sprockets carefully for signs of
deterioration. Make sure the belt
is always kept free of any debris
and clean it with water and a small
amount of soap if need be. Dirt and
dust hasten wear, which may cause
the belt to break unexpectedly.
When the belt is worn it will need
replacing. You can contact us
via the chat in the app or online
to source a new one.
Chain drive
For Core models, the chain drive
system requires regular lubrication
to keep it running smoothly. It is
suggested to lubricate the chain
every 250km ridden.
Using only chain lubricant,
apply it to the inside of the chain
links while turning the crank arms
backward. Once finished, turn
the crank arm a couple more turns
backward then wipe away any
excess lubricant with a clean cloth.
When the chain is worn it will need
replacing. You can contact us via
the chat in the app or online to
source a new one.
Motor
For any motor-related issues,
please contact us directly rather
than trying to fix them yourself.
The motor is an auxiliary motor
limited to 250W of power and
provides assistance up to 25 km/h,
in compliance with EU regulations.
Note that motor assistance will not
function below -10°C or above
+60°C. The motor assistance
system’s A-weighted emission
sound pressure level at the rider’s
ears is less than 70 dB(A).
To Next Page
Loading...
