COX Wireless 4K Contour Stream Player - Quick Start Guide; Connecting Your Contour Stream Player; Activating Your Contour Stream Player; Setting Up Your Voice Remote

A
B
C
Set up your Voice remoteActivate your Contour Stream Player
Quick start instructions
Plug in your Contour Stream Player
Start by turning on your TV.
Using the source or input button on your original TV remote, select the
HDMI connection that matches the HDMI port you plugged the cable into earlier.
You'll be prompted to follow on–screen instructions. Then hang tight for a few
minutes for the activation of your Contour Stream Player to finish.
Now that your Contour Stream Player is activated, simply follow the on-screen instructions
to set up your new Voice remote. When you see "All Set", press OK on your Voice remote.
For help programming and troubleshooting your remote, visit Cox.com/remote-help.
For quick how-to videos, go to Cox.com/support. Check out the
enclosed troubleshooting tips and FAQs card for more information.
We're
here to
help.
Before you get started, we recommend you use the new cables included in your kit.
First, make sure that your Gateway is installed and that the is internet working.
They both need to be up and running before continuing this installation.
Then, plug the blue end of the HDMI cable into the HDMI port on the back of
your Contour Stream Player and plug the other black end into the desired HDMI port
on your TV. Make note of which TV HDMI port you plug it into.
Lastly, connect the power cord into the power port on the back of your
Contour Stream Player and plug the other end into an electrical outlet. This will
power it on. Also make sure the electrical outlet isn't connected to a dimmer.
2
3
2
3
1