H: Remove the six cross recessed pan head screws and take off the decorative strip.
I: Locate two screws which secure lower rear cover. Slacken and remove these two screws and take off the rear
cover.
J: Slacken and remove the two screws which secure the massage mechanism cover. Then slip the massage
mechanism cover to left side. Then it can be taken away.
J: Disconnect all the wire connectors on the massage mechanism PCB. Then use long nose long nose pliers to detach
the PCB from the scaffoldings.
Locate the six screws. Decoration strip has been taken off.
Locate the two screws. Rear cover has been taken off.
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn
To Next Page
