Installationlnstructions
I
, if iii , '_ ,m,
Kit Contents:
Ref. Part No, Q_y,
1 1726453 t
2 1726578 1
3 1729582 I
4 171600 '1
5 1933988 B
6 "1960096 '1
7 1960393 "]
8 1933896 1
9 1927557 10
10 1931332 10
11 1716150 1
12 1726913 1
50" MULCH KIT
WITH BAFFLES
PART NO. 1687050
MODEL 107.277740
I I I II _
7..-_
s 4
l®8
BLAOE,Mower _1 I_X\ N "_ _ ® ®
BAFFEL ASSEMBLY _._XX. 5 --_ Q o I ,_
STRAP, Rubber X \\"_ I_=_=I _ Jl J
NUT,Pus.,_16 \ _ I" " I _ "
WASHER N _,_'_//.) _ -- -- --
SCREW, Philllps,#10-24xl _ _/ .
NUT. Hex, Nylock,#10-24 _ _ _ _ 11
NUT, Hex, RangeLock, 5/16-18 /'X_ _ I _'_ _ I
CARRIAGE BOLT,5/16-18x 5/8 ./ _ L- a
BAFFLE& DEFLECTOR, LH 12 _-. _ • _J
BAFFLE &DEFLECTOR, RH _'
o
J
Figure 1.' Contents
_ WARNING 1
Before beginning any servise work turn off the
PTO, set the paridng brake, turn off the ignition,
remove the key, and disconnect the spark plug
wire(s).
INSTALLATIGN
LOosEN
1, Remove the mower deck. Refer to Operator's
Manual (see Mower Deck Removal & Installat(on).
2. See Figure 2. Remove the RH blade. Usa a block of
wood to prevent blade rotation while loosening the
capscrew by turning itcounterolockwise.
3. Remove the capscrew (D, Figure 3). spring washer
(C), hex washer (B), and blade (E).
4. Reinstall the blade with the liftwings (E, Figure 3)
pointing up toward the mower deck as shown.
5. Reinstall the hex washer (B, Figure 3), spring washer
(C) and capscrew (D). Use a wooden block (A) to
prsveP.tblade foliationwhile tightening the capscrew
(D) to 45-55 ft. Ihs. (61-75 N.m). Turn capscrew
clockwise to tigh:ten.
Flgul_ 2. Blade Re noval
Figure 3. Blade InJitallation
A. 4x4 Wood Blocl
1 B. Hex Washer
C. Spring Washer
D. Blade _._r---'_-_
E- Blade w/Lift W_r 1=
To Next Page
Need help?
General