page 1
MODEL: WUCI-1000
INSTALLATION AND OPERATING INSTRUCTIONS
This remote control is designed to separately control your ceiling fan speed and light brightness. There are four buttons to control the fan speed.
The light dimmer button controls the light brightness. The red indicator on the transmitter will light when any button is pressed.
This control is for ceiling fans with LED lighting only.
• DANGER: HIGH VOLTAGE! Household electrical power can cause serious injury or death. Disconnect source of electrical power to the ceiling fan
by removing fuse or switching off circuit breaker. Make sure all electrical connections comply with local codes, ordinances, the National Electrical
Code, and ANSI/NFPA 70-1999. If you are unfamiliar with electrical wiring, please use a qualified and licensed electrician.
WARNING: To reduce the risk of fire, electrical shock, or personal injury, wire connectors provided with the remote control receiver are designed to accept only one
12-gauge house wire and no more than two lead wires from the receiver. If your house wire is larger than 12-gauge or there is more than one house wire to connect to
the two receiver wires, consult an electrician for the proper size wire connectors to use.
•
Choking Hazard - Small parts. Keep batteries away from children.
CAUTION
• To reduce the risk of fire or electric shock, do NOT use a full-range dimmer switch to control the fan speed.
• Do not use this remote control with incandescent bulbs.
• Do not use this remote control with solid state ceiling fans. Electrical source and fan must be 120 volts, 60 Hz.; Maximum fan motor amps: 1.5;
Maximum LED light watts: 50W; Electronic ballast (LED lights or CFL lights) 300VA.
• “DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR LEAK.” - When disposing of household alkaline batteries, it is best to check with your local
and state recycling or household hazardous waste coordinators concerning the specifics of the program in your area. You may also locate a recycling center by calling
1-800-8-BATTERY or 1-877-2-RECYCLE or visit www.epa.gov/epawaste/index.htm or www.earth911.org for more information.
A. To use wall control as a remote control (Fig. 3), cut each wire on wall control.
Use wire cutters to cut off each wire as close to the wall control as possible.
B. Place wall control into BOTTOM part of remote control cover, aligning posts in top of remote
control cover with post holes in the bottom. Squeeze top and bottom of remote control cover
until you hear a click at each end, indicating the remote control cover has closed completely.
C. Install 12-volt battery (included). NOTE: Battery is NOT rechargeable. Remove battery with
low or no charge and dispose of properly.
WARNING: Battery is to be inserted with the correct polarity.
CAUTION: Store the handheld remote control away from excess heat or humidity.
To prevent damage to handheld remote control, remove the battery if handheld remote
control will not be used for long periods.
ASSEMBLY OF HANDHELD REMOTE CONTROL
(Figure 3)
IMPORTANT: Fan speed and light control (if applicable) will not be activated by remote if pull chains
for fan and light are not set to the HIGH and ON positions, respectively.
1. Disconnect source of electrical power to the ceiling fan by removing fuse or switching off circuit
breaker.
2. Lower ceiling fan canopy from the hanging bracket.
3. Disconnect existing wiring between ceiling fan and supply at electrical outlet box.
4. Lay the black antenna wire on top of the receiver and slide the receiver (flat side up) into the
mounting bracket.
5. Using wire connectors supplied, make wire connections as follows: (Fig.2)
CONNECT: TO:
GREEN fan wire......................................................BARE supply wire
BLACK receiver wire (AC IN L)...............................BLACK supply wire
WHITE receiver wire (AC IN N)...............................WHITE supply wire
WHITE receiver wire (TO MOTOR N)......................WHITE fan wire
BLACK receiver wire (TO MOTOR L)......................BLACK fan wire
BLUE receiver wire (FOR LIGHT)............................BLUE light wire (from fan)
Note: If other fan or supply wires are different colors than those mentioned, have this unit installed by
a qualified electrician.
6. Wrap each wire connector separately with electrical tape (not included) as an extra safety
measure.
7. Push all connected wires up into outlet box. Make sure antenna rests outside of hanging bracket.
8. Re-install the canopy on the hanging bracket.
Fig. 3
BATTERY
FACEPLATE
SAFETY INFORMATION
INSTALLATION OF RECEIVER
ASSEMBLY OF HANDHELD REMOTE CONTROL
Modications not approved by the party responsible for compliance could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
Fig. 1
CAUTION: FOR MOUNTING RECEIVER,
CEILING ANGLE SHALL NOT EXCEED
19 DEGREES; RECEIVER MODEL: UC7067RYA
19˚
20˚
and
above
RECEIVER
MOUNTING
BRACKET
DOWNROD
AC SUPPLY
BLACK
WHITE
BARE GREEN
BLACK
WHITE
BLUE BLUE
BLACK
WHITE
ANTENNA
AC SUPPLY
BLACK
WHITE
BLACK
WHITE
FILTER
Fig. 2
ELECTRICAL TAPE
To Next Page
Need help?
General
