KNOWYOURELECTRICBLOWER
READTHIS OPERATOR'SMANUALAND SAFETYRULESBEFOREOPERATINGYOUR
UNIT,Compare the illustrationsto your unitto familiarize yourself with the location
of the various controls and adjustments, Save this manual for future reference,
Top Handle
On/Off X_
Switch
BlowerTube
f
AirVents Cdlectian Bag
Rear Handle
Cord Retainer
InletC_er Latch
UpperVacuumTube LowerVacuumTube
The ON/OFFSWITCH is used to acti- open and close the inlet cover.
vate the motor. The NOZZLE isdesigned to direct the
The INLET COVERLATCH isused to flow ofair.
OPERATING INSTRUCTIONS
STOPPING YOUR UNIT
Slide the ON/OFF switch to the OFF
position.
STARTING YOUR UNIT
Your unit has two run positions,LOW
and HIGH. Slide the switchto one of
these positions to turn on the unit.
'_ WARNING : Do not use the unit
without the blower tubes, or collection
bag properly attached to avoid flying
debris and/or impeller contact which
can cause serious injury. Always wear
eye protection to prevent rocks or de-
brisfrom being blown or ricocheting
intothe eyes and face which can result
in blindness or serious injury,
USING YOUR UNIT AS A BLOWER
Use your unit as a blower for:
• Sweeping debris or grass clippings
from driveways, sidewalks, patios,
etc.
• Blowing grass clippings, straw, or
leaves into piles, or removing debris
from corners, around joints, or be-
tween bricks.
Direct air flow by directing the nozzle
down otto one side. Always work
away from solid objects such as walks,
large stones, vehicles, and fences.
Clean corners by starting incomers
and moving outward. This will help
prevent an accumulation of debris
which could fly intoyour face.
Be careful when working near plants,
The force of the air Could damage
tender plants.
E_ower Operating
Position
8
To Next Page
Loading...
